Pages - Menu

Pages - Menu

Jumat, 11 September 2015

tumpuan roll pada analisa FE menggunakan element solid

[ draft ]


simple supported beams with uniform loads. symmetric, only half to be modeling.

2015-09-11 23_19_11-

(concrete beam 200x400mm, width and height respectively, length 4.000/2=2.000mm)


2015-09-11 23_22_32-

model #1 rolled support (trans-y fixed only)

results,

2015-09-11 23_19_44-

deflections are too small


2015-09-11 23_20_00-

very disturbed regions at support (?)


2015-09-11 23_20_09-

up direction tension stress occurs at edge face of beams (?)


2015-09-11 23_21_45-

2015-09-11 23_20_34-

clamped action with couple forces (not as expected)


model #2 face support compression only (springs trans-y only)


results,


2015-09-11 23_32_31-


2015-09-12 04_18_25-


2015-09-11 23_27_16-


smooth stress contours without disturbed regions at support


2015-09-11 23_27_31-


singularities still exist, how about using contact element?


2015-09-11 23_27_41-


2015-09-11 23_28_13-


no couple force occurs (okey, as expected)


model #3 face contact support with steel plate element


solid cylinder (Ln=1875mm),


2015-09-12 04_15_32-Calculix Graphix


2015-09-12 04_16_03-Calculix Graphix


2015-09-12 04_12_31-Calculix Graphix


2015-09-12 04_13_27-Calculix Graphix


2015-09-12 04_14_24-Calculix Graphix


2015-09-12 04_49_47-Calculix Graphix


model #4 face contact support with steel plate element


solid rectangular plate(Lt=2.000mm),


2015-09-12 08_28_59-Calculix Graphix


2015-09-12 08_29_36-Calculix Graphix


2015-09-12 08_31_06-Calculix Graphix


2015-09-12 08_31_43-Calculix Graphix


2015-09-12 08_32_39-Calculix Graphix


2015-09-12 08_33_35-Calculix Graphix


support and loads must be realistic enough to avoid singularities or concentrated high stress in specific areas. even this phenomenon are most nature and fact it's always exist. plastic analysis need to be conduct if stress contour has shown exhibit beyond of elastic ranges. this required to study plastic stress/strain distribution and deformation.



pemodelan tumpuan roll perlu diwakilkan dengan kontak, disesuaikan keadaan real atau sesungguhnya.

Tidak ada komentar:

Posting Komentar